RFM23
10
19.2
20
40
9.6
10
8.00
1.00
1.00
4.00
1.02
1.00
2.00
1.00
1.00
1.00
6.00
2.00
90
0
0
0
0
0
0
0
0
0
1
1
1
0
1
1
0
0
0
0
0
0
0
0
0
3
1
1
4
1
1
5
1
3
F
E
8
190
051EC
13A93
147AE
0A3D7
13A93
147AE
147AE
1999A
1D7DC
11111
11111
15555
02B
37.7
37.7
95.3
75.2
75.2
112.1
75.2
90
068
064
0C8
068
064
064
050
045
078
078
060
4EE
521
0A6
4D5
521
291
668
76E
446
0B8
2AD
20
40
38.4
40
19.6
20
40
40
50
25
57.6
100
100
125
28.8
50
191.5
620.7
335.5
300
125
7.1.1. Advanced FSK and GFSK Settings
In nearly all cases, the information in Table 16, ―RX Modem Configurations for FSK and GFSK,‖ can be used to
determine the required FSK and GFSK modem parameters. The section includes a more detailed discussion of
thevarious modem parameters to allow for experienced designers to further configure the modemperformance.
In FSK or GFSK mode the receiver can handle a wide range of modulation indices ranging from 0.5 up to 32. The
modulation index (h) is defined by the following:
2×Fd
Rb×(1+enmanch)
h =
When the modulation index is 1 or higher the modulation bandwidth can be approximated by the following equation:
Rb
2
BWmod
=(
×(1+enmanch)+2×Fd
)
When the modulation index is lower than 1 the modulation bandwidth can be approximated by the following:
BWmod
=(
Rb×(1+enmanch)+ Fd
)
Where BWmod is an approximation of the modulation bandwidth in kHz, Rb is the payload bit rate in kbps, Fd is the
frequency deviation of the received GFSK/FSK signal in kHz and enmanch is the Manchester Coding parameter
(see Reg. 70h, enmach is 1 when Manchester coding is enabled, enmanch is 0 when disabled).
The bandwidth of the channel select filter in the receiver might need some extra bandwidth to cope with tolerances
in transmit and receive frequencies which depends on the tolerances of the applied crystals. When the relative
frequency error (Ferror) between transmitter and receiver is less than half the modulation bandwidth (BWmod) then
the AFC will correct the frequency error without needing extra bandwidth. When the frequency error exceeds
BWmod/2 then some extra bandwidth will be needed to assure proper AFC operation under worst case conditions.
When the AFC is enabled it is recommended to set the bandwidth of the channel select filter (BWch-sel) according
to the formulas below:
BWmod
F
error
≤
=> BW ch-sel = BWmod
2
45
Tel: +86-755-82973805
Fax: +86-755-82973550
E-mail: sales@hoperf.com
http://www.hoperf.com
HOPERF [ HOPERF ]
