RFM22
6.3. Packet Handler TX Mode
If the TX packet length is set the packet handler will send the number of bytes in the packet length field before
returning to ready mode and asserting the packet sent interrupt. To resume sending data from the FIFO the
microcontroller needs to command the module to re-enter TX mode Figure 18 provides an example transaction
where the packet length is set to three bytes.
Figure 18. Multiple Packets in TX Packet Handler
6.4. Packet Handler RX Mode
6.4.1. Packet Handler Disabled
When the packet handler is disabled certain portions of the packet handler are still required. Proper modem operation requires
preamble and sync, as shown in Figure 19. Bits after sync will be treated as raw data with no qualification. This mode allows for
the creation of a custom packet handler when the automatic qualification parameters are not sufficient. Manchester encoding is
supported but the use of data whitening, CRC, or header checks is not.
Figure 19. Required RX Packet Structure with Packet Handler Disabled
6.4.2. Packet Handler Enabled
When the packet handler is enabled, all the fields of the packet structure need to be configured. If multiple packets
are desired to be stored in the FIFO, then there are options available for the different fields that will be stored into
the FIFO. Figure 20 demonstrates the options and settings available when multiple packets are enabled. Figure 21
demonstrates the operation of fixed packet length and correct/incorrect packets.
Figure 20. Multiple Packets in RX Packet Handler
39
Tel: +86-755-82973805
Fax: +86-755-82973550
E-mail: sales@hoperf.com
http://www.hoperf.com
HOPERF [ HOPERF ]
