HI-3182, HI-3183, HI-3184, HI-3185, HI-3186, HI-3187, HI-3188
FUNCTIONAL DESCRIPTION
The SYNC and CLOCK inputs establish data synchronization
utilizing two AND gates, one for each data input. Each logic
input, including the power enable (STROBE) input, are
TTL/CMOS compatible.
Figure 1 illustrates a typical ARINC 429 bus application.
Three power supplies are necessary to operate the HI-3182;
typically +15V, -15V and +5V. The chip also works with ±12V
supplies. The +5V supply can also provide a reference
voltage that determines the output voltage swing. The
differential output voltage swing will equal 2V
REF
. If a value of
V
REF
other than +5V is needed, a separate +5V power supply
is required for pin V
1
.
With the DATA (A) input at a logic high and DATA (B) input at a
logic low, A
OUT
will switch to the +V
REF
rail and B
OUT
will
switch to the -V
REF
rail (ARINC HIGH state). With both data
input signals at a logic low state, the outputs will both switch to
0V (ARINC NULL state).
The driver output impedance, R
OUT
, is nominally 75, 26 or 0
ohms depending on the option chosen. The rise and fall times
of the outputs can be calibrated through the selection of two
external capacitor values that are connected to the C
A
and C
B
input pins. Typical values for high-speed operation
(100KBPS) are C
A
= C
B
= 75pF and for low-speed operation
(12.5 to 14KBPS) C
A
= C
B
= 500pF.
The C
A
and C
B
pins swing between +5V and ground allowing
the switching of capacitor values with an external single-
supply analog switch.
The ARINC outputs can be put in a tri-state mode by applying
a logic high to the STROBE input pin. If this feature is not
being used, the pin should be tied to ground. The STROBE
function is not available in the 14 & 16-pin SOIC package
configurations where the pin is internally connected to
ground.
The ARINC outputs of the HI-3182, HI-3184 and HI-3187 are
protected by internal fuses capable of sinking between 800 -
900 mA for short periods of time (125
µ
s).
+5V
+15V
V
REF
DATA (A)
V1
SYNC
CLOCK
OUT
+V
INPUTS
DATA (B)
C
C
STROBE
GND
-V
TO ARINC BUS
B
-15V
Figure 1.
ARINC 429 BUS APPLICATION
REF
+V
C
A
Shorted on
HI-3186, HI-3187, HI-3188
DATA (A)
LEVEL SHIFTER
AND SLOPE
CONTROL (A)
CLOCK
24.5Ω
OUTPUT
DRIVER (A)
C
L
SYNC
LEVEL SHIFTER
AND SLOPE
CONTROL (B)
24.5Ω
OUTPUT
DRIVER (B)
R
L
13Ω
F
A
13Ω
F
B
DATA (B)
V
1
STROBE
CURRENT
REGULATOR
Shorted on
HI-3183, HI-3186
HI-3187, HI-3188
Shorted on
HI-3183, HI-3185
HI-3186, HI-3188
GND
-V
C
B
B
OUT
Figure 2.
FUNCTIONAL BLOCK DIAGRAM
HOLT INTEGRATED CIRCUITS
2
HOLTIC [ HOLT INTEGRATED CIRCUITS ]
