SURFACE MOUNT DEVICE LED
REV:A / 03
Part No. : 0603KRCT
ꢀCleaning
ꢀ
ꢀ
ꢀ
If cleaning is required , use the following solutions for less than 1 minute and less than 40℃.
Appropriate chemicals: Ethyl alcohol and isopropyl alcohol.
Effect of ultrasonic cleaning on the LED resin body differs depending on such factors as
the oscillator output, size of PCB and LED mounting method. The use of ultrasonic
cleaning should be enforced at proper output after confirming there is no problem.
ꢀSuggest Soldering Pad Dimensions
Direction of PWB camber
and go to reflow furnace
ꢀSuggest IR Reflow Soldering Profile Condition:
240° C(MAX)
Rising
+5℃/sec
(MAX)
Cooling
-5℃/sec
(MAX)
C
C
+5℃/sec
(MAX)
Time
DRAWING NO. : DS-74-03-0007
DATE : 2004-06-07
PAGE
7 of 10
HB [ HB ELECTRONIC COMPONENTS ]
