BLOCK CHARACTERISTICS
GPinhole Holder Block A11027
The A11027 is a holder block for mounting a pinhole. The screws can
be used to adjust the pinhole's position in the XY directions. The built-in
lens collimates the light that passes through the pinhole and converges
the light on a photodetector.
There is a base attached to the holder block through the M3 screw
holes in the bottom of the block. If necessary, this base can be re-
moved and re-attached to the side of the block.
SPECIFICATIONS
Applicable Pinhole XY Axis Range Adjustment Focal
Type No.
Weight
Mount Size
of Motion
Screw Pitch Length
Approx. 180 g
(including
Diameter: 16 mm
A11027
1.2
0.25 mm 15 mm
Thickness:
1.58 mm to 1.6 mm
NOTE: • The collimate status changes depending on the pin-
hole diameter and the wavelength. (The assumed
wavelength is between 400 nm and 700 nm.)
• The pinhole is not included. Use a pinhole that is in-
stalled in a mount. (Products by companies such as
SIGMA KOKI CO., LTD.; SURUGA SEIKI CO., LTD.;
and CVI Melles Griot can be used.)
the base)
* Supplied: Screw ring tool and hex wrench
Dimensional Outlines (Unit: mm)
(27.526)
8.0
Y-AXIS ADJUSTMENT SCREW
ADJUSTMENT: 1.2
(REFERENCE PLANE OF
THE PINHOLE MOUNT) 17.746
C-MOUNT ANGLE
ADJUSTMENT RING
• Be careful to install the pinhole so that it faces in the
correct direction.
• When installing a pinhole, be careful to keep it clean
and to avoid getting fingerprints on it.
50.0
11.5 1.5
(0.22)
2-M3 DEPTH 3
12.0
(ASSUMED PINHOLE PLANE) 17.526
10.0
(FOR HOLDING THE
BLOCK IN PLACE)
PINHOLE MOUNTING
SCREW RING
X-AXIS ADJUSTMENT
SCREW
ADJUSTMENT: 1.2
Transmittance for the Collimation Lens (Typical)
TPMOB0233EA
100
80
60
40
20
0
C-MOUNT
(FEMALE)
22.95
50.0
APPLICABLE PINHOLE MOUNT SIZE
DIAMETER: 16. THICKNESS: 1.6
BASE (REMOVABLE)
2-M3
BOLTS WITH HEXAGONAL HOLES
FOR ATTACHING THE BASE
30.0
2- 4.5
(FOR HOLDING THE BASE IN PLACE)
M4 DEPTH 5
(FOR HOLDING THE
BLOCK IN PLACE)
60.0
BASE MOUNTING SURFACE
TACCA0070EA
Extended Example of Microscope
Connecting the A11027 pinhole holder block to the C-mount port of a
microscope configures a confocal optical system. Light passing
through the pinhole is collimated by the lens in the block and is effi-
ciently guided to the PMT module.
300
400
500
600
700
800
WAVELENGTH (nm)
FILTER BLOCK A10033-xx
PMT MODULE
ADAPTER BLOCK
A10030-01
PINHOLE HOLDER BLOCK A11027
MICROSCOPE C-MOUNT PORT
MICROSCOPE
16