欢迎访问ic37.com |
会员登录 免费注册
发布采购

GK509-CHIP 参数 Datasheet PDF下载

GK509-CHIP图片预览
型号: GK509-CHIP
PDF下载: 下载PDF文件 查看货源
内容描述: [Audio Amplifier, DIE]
分类和应用: 放大器商用集成电路
文件页数/大小: 5 页 / 85 K
品牌: GENNUM [ GENNUM CORPORATION ]
 浏览型号GK509-CHIP的Datasheet PDF文件第2页浏览型号GK509-CHIP的Datasheet PDF文件第3页浏览型号GK509-CHIP的Datasheet PDF文件第4页浏览型号GK509-CHIP的Datasheet PDF文件第5页  
Class A Amplifier with 2 DC Coupled
Gain Blocks & Schottky Diodes
GK509 DATA SHEET
FEATURES
100
µ
A typical current drain
low noise and distortion
1.0 to 5 VDC operating range
DC coupled stages
Class A output stage
Schottky diodes for MPO control
variable transducer current
4 k
microphone decoupling resistor
STANDARD PACKAGING
• 8 pin PLID
®
• Chip ( 61 x 55 mils)
DESCRIPTION
The GK509 is a Class A amplifier utilizing Gennum’s
proprietary low voltage JFET technology. It consists of a
single-ended, low noise inverting gain block, a Class
A output s t a g e , a n o n - c h i p m i c r o p h o n e d e c o u p l i n g
r e s i s t o r , and a pair of Schottky diodes for symmetrical
peak clipping.
Block A typically has an open loop voltage gain of 56 dB,
with the closed loop gain set by the ratio of the feedback
resistor to the source impedance. It is recommended that
the maximum closed loop gain be 20 dB lower than the
open loop gain. All blocks of the device are internally bias
compensated, preventing any DC current flow via external
feedback resistors. Without this compensation audible
scratchiness would be present during changes in volume
control settings.
The output stage of the GK509 is a Class A current drive.
It has a fixed reference voltage of typically 30 mV at pin 2
of the device. The current that flows in the transducer is the
ratio of the 30 mV reference voltage and the on-chip
emitter resistor (R ). To increase the bias current in the
E
transducer, simply place an external R
E
resistor from pin 2
to ground, thereby decreasing the equivalent emitter resistance
and increasing the current.
The GK509 also contains a pair of Schottky diodes in the
feedback configuration of the output stage, which provides
approximately 12 dB of MPO control.
VB
6
VMIC
5
7
21K
R
MIC
MPO
A IN
4
-A
-B
B OUT
8
2
R
E
R
E
3
A OUT
1
GND
All resistors in ohms, all capacitors in farads unless otherwise stated
Revision Date: January 2001
BLOCK DIAGRAM
Document No. 510 - 69 -06
GENNUM CORPORATION P.O. Box 489, Stn. A, Burlington, Ontario, Canada L7R 3Y3 tel. +1 (905) 632-2996
Web Site: www.gennum.com E-mail: hipinfo@gennum.com