GL852 USB 2.0 MTT HUB Controller
Figure 5.3 - RESET# (External Reset) setting and application
GL852 internally contains a power on reset circuit. The power on sequence is depicted in the next picture.
To fully control the reset process of GL852, we suggest the reset time applied in the external reset circuit
should longer than that of the internal reset circuit.
VCC(3.3V)
Power good voltage, 2.5~2.8V
2.7
s
Internal reset
External reset
Figure 5.4 - Power on sequence of GL852
5.2.2 PGANG/SUSPND Setting
To save pin count, GL852 uses the same pin to decide individual/gang mode as well as to output the
suspend flag. The individual/gang mode is decided within 20us after power on reset. Then, about 50ms later,
this pin is changed to output mode. GL852 outputs the suspend flag once it is globally suspended. For
individual mode, a pull low resister greater than 100KΩ should be placed. For gang mode, a pull high
resister which greater than 100K should be placed. In figure 5.6, we also depict the suspend LED
Ω
indicator schematics. It should be noticed that the polarity of LED must be followed, otherwise the suspend
current will be over spec limitation (2.5mA).
©2000-2007 Genesys Logic Inc. - All rights reserved.
Page 19