MB90560/565 Series
Pin No.
Cir-
cuit
State/
Pin
Name
Function
Description
Type* at Reset
QFPM06 LQFPM09 SDIP
P30 to
P35
I/O ports
Event output pins for the output compare and wave-
form generator output pins. The pins output the
specified waveform generated by the waveform
generator. If not using waveform generation, these
terminals enable output compare event output to
use as output compare outputs. When used as a
port, set the corresponding bits in the analog input
enable register (ADER) to “port”.
51 to 56 50 to 55 58 to 63
E
RTO0
to
RTO5
P36
I/O port
Serial data input pin for UART ch0.
59
58
2
D
This pin is used continuously when input operation
is enabled for UART ch0. In this case, do not use as
a general input pin.
SIN0
Port
inputs
(Hi-Z)
P37
SOT0
P40
I/O port
60
61
59
60
3
4
D
D
Serial data output pin for UART ch0.
Output operates when UART ch0 output is enabled.
I/O port
Serial clock I/O pin for UART ch0.
Output operates when UART ch0 clock output is
enabled.
SCK0
P41 to
P46
I/O ports
62 to 64, 61 to 64,
5 to 10
D
PPG0
to
PPG5
Output pins for PPG ch0 to ch5.
The outputs operate when output is enabled for
PPG ch0 to ch5.
1 to 3
1, 2
P50 to
P57
I/O ports
Analog
inputs
4 to 11
3 to 10 11 to 18
F
Analog input pins for the A/D converter. Input is
available when the corresponding analog input en-
able register bits are set. (ADER : bit0 to bit7)
AN0 to
AN7
Power
12
13
14
11
12
13
19
20
21
AVCC
AVR
AVSS
supply VCC power supply input pin for A/D converter.
input
Refer-
Reference voltage input pin for A/D converter.
G
ence volt-
Ensure that the voltage does not exceed VCC.
age input
Power
supply VSS power supply input pin for A/D converter.
input
* : See “■ I/O CIRCUITS” for details of the circuit types.
(Continued)
11
FUJITSU [ FUJITSU ]
