MB95120MB Series
■ PROGRAMMING FLASH MEMORY MICROCONTROLLERS USING PARALLEL
PROGRAMMER
• Supported Parallel Programmers and Adapters
The following table lists supported parallel programmers and adapters.
Package
Applicable adapter model
Parallel programmers
AF9708 (Ver 02.35G or more)
AF9709/B (Ver 02.35G or more)
AF9723+AF9834 (Ver 02.08E or more)
FPT-100P-M20
TEF110-95F128HSPFV
FPT-100P-M06
TEF110-95F128HSPF
Note : For information on applicable adapter models and parallel programmers, contact the following:
Flash Support Group, Inc. TEL: +81-53-428-8380
• Sector Configuration
The individual sectors of Flash memory correspond to addresses used for CPU access and programming by
the parallel programmer as follows:
• MB95F128MB/F128NB/F128JB (60 Kbytes)
Flash memory
CPU address
Programmer address*
1000H
71000H
SA1 (4 Kbytes)
1FFFH
2000H
71FFFH
72000H
SA2 (4 Kbytes)
SA3 (4 Kbytes)
SA4 (16 Kbytes)
SA5 (16 Kbytes)
SA6 (4 Kbytes)
SA7 (4 Kbytes)
SA8 (4 Kbytes)
SA9 (4 Kbytes)
2FFFH
3000H
72FFFH
73000H
3FFFH
4000H
73FFFH
74000H
7FFFH
8000H
77FFFH
78000H
BFFFH
C000H
7BFFFH
7C000H
CFFFH
D000H
7CFFFH
7D000H
DFFFH
E000H
7DFFFH
7E000H
EFFFH
F000H
7EFFFH
7F000H
FFFFH
7FFFFH
*: Programmer addresses are corresponding to CPU addresses, used when the parallel programmer
programs data into Flash memory.
These programmer addresses are used for the parallel programmer to program or erase data in Flash
memory.
• Programming Method
1) Set the type code of the parallel programmer to 17222.
2) Load program data to programmer addresses 71000H to 7FFFFH.
3) Programmed by parallel programmer
19
FUJITSU [ FUJITSU ]
