Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.2.4 GPIO [24:31] Connector CN6
Figure 5.5
GPIO[24:31] Connector CN6
VCN2 Pin No
Connecto
IO
Signal name
Description
r pin
type
32-PIN
48-PIN
64-PIN
(13)
GPIO24
1
2
3
4
5
6
7
8
9
-
-
-
-
-
-
-
-
-
35
36
37
38
41
42
43
44
-
43
44
45
46
47
48
49
50
-
IO
IO
IO
IO
IO
IO
IO
IO
-
GPIO port, data bit 24
GPIO port, data bit 25
GPIO port, data bit 26
GPIO port, data bit 27
GPIO port, data bit 28
GPIO port, data bit 29
GPIO port, data bit 30
GPIO port, data bit 31
Ground pin
(13)
GPIO25
(13)
GPIO26
(13)
GPIO27
(13)
GPIO28
(13)
GPIO29
(13)
GPIO30
(13)
GPIO31
GND
3.3V(14)
10
11
12
-
-
-
-
-
-
-
-
-
3.3V power rail.
Ground pin
GND
5V(15)
5V power rail.
Notes:
(13) All VNC2‟s IO pins can be driven from 3.3V LVTTL TTL logic levels.
The use of these pins for GPIO is set by the IOMUX on the VNC2 device. The pins are shared by other
connectors on the board. Care should be taken to ensure that pins are not driven from other headers
on the board.
(14) This pin is connected to 3.3V regulator output. External device can draw no more than 100mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
(15) This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from power supply and no more than 50mA when the board is powered from USB bus.
Table 5.4
GPIO port connector CN6
Copyright © 2010 Future Technology Devices International Limited
17