Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.10
User LEDs. LED3 – LED6.
Figure 5.15
User LEDs
Four LEDs is provided on board. The LEDs enabled or disabled via jumpers JP7 – JP10. The LEDs are
controlled by the IOBUS signals on the VNC2.
Note - LED5 is also connected to jumper JP1 on the board. Care should be taken to ensure that LED is
not being driven by JP1 when controlling the LED from the VNC2.
VCN2 pin number
Designator
32-PIN
LED3
LED4
LED5
(40)
LED6
12
14
-
-
48-PIN
12
13
46
45
64-PIN
12
13
29
31
Notes:
(40)
LED5 is also connected to jumper JP1 on the board. Care should be taken to ensure
that LED is not being driven by JP1 when controlling the LED from the VNC2. Further,
when running VNC1L migrated firmwares, LED5 is not available on 48-pin package as
the I/O signal is used for interface selection purposes by the firmware.
Table 5.15
User LED connections
Copyright © 2010 Future Technology Devices International Limited
29