Document Reference No.: FT_000065
TTL-232R-PCB TTL TO USB SERIAL CONVERTER PCB Datasheet Version 1.01
Clearance No.: FTDI# 54
E-Mail (Support): cn.support@ftdichip.com
E-Mail (General Enquiries): cn.admin1@ftdichip.com
Web Site URL: http://www.ftdichip.com
Distributor and Sales Representatives
Please visit the Sales Network page of the FTDI Web site for the contact details of our distributor(s) and
sales representative(s) in your country.
Appendix A - PCB EEPROM Configuration. A user area of the internal EEPROM is available to system
designers to allow storing additional data. The internal EEPROM descriptors can be programmed in circuit,
over USB without any additional voltage requirement. It can be programmed using the FTDI utility
software called
which can be downloaded from FTDI Utilities on the FTDI website
Lower Operating and Suspend Current.
The FT232R has a low 15mA operating supply current and a
very low USB suspend current of approximately 70μA.
Low USB Bandwidth Consumption.
The USB interface of the FT232R, and therefore the TTL-232R_PCB
has been designed to use as little as possible of the total USB bandwidth available from the USB host
controller.
High Output Drive Option.
The UART interface I/O pins on the TTL-232R_PCB (RXD, TXD, RTS#, and
CTS#) can be configured to use the FT232R’s high output drive option. This option allows the FT232R
I/O pins to drive up to three times the standard signal drive level. This allows multiple devices to be
driven, or devices that require a greater signal drive strength to be interfaced on the PCB. This option is
enabled in the internal EEPROM.
UART Pin Signal Inversion.
The sense of each of the UART signals can be individually inverted by
configuring options in the internal EEPROM. For example CTS# (active low) can be changed to CTS
(active high), or TXD can be changed to TXD#.
FTDIChip-ID™.
The FT232R includes the new FTDIChip-ID™ security dongle feature. This FTDIChip-ID™
feature allows a unique number to be burnt into each FT_232RQ during manufacture. This number cannot
be reprogrammed. This number is only readable over USB can be used to form the basis of a security
dongle which can be used to protect any customer application software being copied. This allows the
possibility of using the TTL-232R_PCB as a dongle for software licensing. Further to this, a renewable
license scheme can be implemented based on the FTDIChip-ID™ number when encrypted with other
information. This encrypted number can be stored in the user area of the FT232R internal EEPROM, and
can be decrypted, then compared with the protected FTDIChip-ID™ to verify that a license is valid. Web
based applications can be used to maintain product licensing this way. An application note, AN232R-02,
available from FTDI website (www.ftdichip.com) describes this feature.
Extended Operating Temperature Range -
The TTL-232R_PCB is capable of operating over an
extended temperature range of -40º to +85ºC thus allowing it to be used in automotive or industrial
applications.
Copyright © 2008 Future Technology Devices International Limited
7
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
