Document No.: FT_000053
FT232R USB UART IC Datasheet Version 2.07
Clearance No.: FTDI# 38
8 Internal EEPROM Configuration
Following a power-on reset or a USB reset the FT232R will scan its internal EEPROM and read the USB
configuration descriptors stored there. The default factory programmed values of the internal EEPROM
are shown in Table 8.1.
Parameter
Value
Notes
USB Vendor ID (VID)
USB Product UD (PID)
Serial Number Enabled?
0403h
6001h
Yes
FTDI default VID (hex)
FTDI default PID (hex)
A unique serial number is generated and
programmed into the EEPROM during device final
test.
Serial Number
See Note
Disabled
Enabling this option will make the device pull down
on the UART interface lines when in USB suspend
mode (PWREN# is high).
Pull down I/O Pins in USB
Suspend
Manufacturer Name
Product Description
Max Bus Power Current
Power Source
FTDI
FT232R USB UART
90mA
Bus Powered
FT232R
Device Type
Returns USB 2.0 device description to the host.
Note: The device is a USB 2.0 Full Speed device
(12Mb/s) as opposed to a USB 2.0 High Speed
device (480Mb/s).
USB Version
0200
Taking RI# low will wake up the USB host controller
from suspend in approximately 20 ms.
Remote Wake Up
High Current I/Os
Load VCP Driver
Enabled
Disabled
Enabled
Enables the high drive level on the UART and CBUS
I/O pins.
Makes the device load the VCP driver interface for
the device.
Default configuration of CBUS0 – Transmit LED
drive.
CBUS0
CBUS1
CBUS2
TXLED#
RXLED#
TXDEN
Default configuration of CBUS1 – Receive LED drive.
Default configuration of CBUS2 – Transmit data
enable for RS485
Default configuration of CBUS3 – Power enable. Low
after USB enumeration, high during USB suspend
mode.
CBUS3
PWREN#
Copyright © 2010 Future Technology Devices International Limited
33
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
