Document No.: FT_000061
FT2232H DUAL HIGH SPEED USB TO MULTIPURPOSE UART/FIFO IC
Datasheet Version 2.09
Clearance No.: FTDI#77
4.8.3 Fast Opto-Isolated Serial Data Interface Example
The following example,Figure 4.16 , shows two Agilent HCPL-2430 (see the semiconductor section at
high speed opto-couplers used to optically isolate an external device which
interfaced to USB using the FT2232H. In this example VCC5V is the USB VBUS supply and VCCE is the
supply to the external device.
Care must be taken with the voltage used to power the photo-LED‟s. It must be the same voltage as that
the FT2232H I/Os are driving to, or the LED‟s may be permanently on. Limiting resistors should be fitted
in the lines that drive the diodes. The outputs of the opto-couplers are open-collector and require a pull-
up resistor.
VCC5V
Cable
8
VCCE
FT2232H
1K
FSDI
HCPL-2430
1
470R
1K
7
6
5
2
3
470R
4
DI
CLK
FSCLK
VCCE
VCC5V
1
470R
FSDO
FSCTS
470R
4
HCPL-2430
8
1K
7
6
1K
DO
CTS
2
3
5
Figure 4.16 Fast Opto-Isolated Serial Interface Example
Copyright © 2010 Future Technology Devices International Limited
36
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
