Document No.: FT_000061
FT2232H DUAL HIGH SPEED USB TO MULTIPURPOSE UART/FIFO IC
Version 2.21
Clearance No.: FTDI#77
Pin No.
Name
OSCI
OSCO
REF
Type
INPUT
OUTPUT
INPUT
INPUT
INPUT
INPUT
INPUT
Description
2
3
Oscillator input.
Oscillator output.
6
Current reference – connect via a 12KΩ resistor @ 1% to GND.
USB Data Signal Minus.
7
DM
8
USB Data Signal Plus.
DP
13
14
TEST
IC test pin – for normal operation should be connected to GND.
Reset input (active low).
RESET#
PWREN#
Active low power-enable output.
PWREN# = 0: Normal operation.
60
36
OUTPUT
OUTPUT
PWREN# =1 : USB SUSPEND mode or device has not been configured.
This can be used by external circuitry to power down logic when device
is in USB suspend or has not been configured.
SUSPEND#
Active low when USB is in suspend mode.
USB Power Save input. This is an EEPROM configurable option used
when the FT2232H is used in a self powered mode and is used to
prevent forcing current down the USB lines when the host or hub is
powered off.
PWRSAV# = 1 : Normal Operation
59
PWRSAV#
INPUT
PWRSAV# = 0 : FT2232H forced into SUSPEND mode.
PWRSAV# can be connected to GND (via a 10KΩ resistor) and another
resistor (e.g. 4K7) connected to the VBUS of the USB connector. When
this input goes high, then it indicates to the FT2232H that it is
connected to a host PC. When the host or hub is powered down then
the FT2232H is held in SUSPEND mode.
Table 3.2 Common Function pins
Pin No.
63
Name
Type
Description
EECS
I/O
EEPROM – Chip Select. Tri-State during device reset.
EECLK
OUTPUT
I/O
Clock signal to EEPROM. Tri-State during device reset. When not in reset, this
outputs the EEPROM clock.
62
EEDATA
EEPROM – Data I/O Connect directly to Data-In of the EEPROM and to Data-Out
of the EEPROM via a 2.2K resistor. Also, pull Data-Out of the EEPROM to VCC via
a 10K resistor for correct operation. Tri-State during device reset.
61
Table 3.3 EEPROM Interface Group
Copyright © 2012 Future Technology Devices International Limited
11
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
