Document Reference No.: FT_000401
USB 2.0 HI-SPEED TO MPSSE CABLE Datasheet
Version 1.0
Clearance No.: FTDI# 214
2.2
Features
Based on the Single chip USB Hi-Speed
FT232H device
USB 2.0 Hi-Speed (480Mbits/Second) and
Full Speed (12Mbits/Second) compatible
Entire USB protocol handled on the chip –
No USB-specific firmware programming
required
USB Type A connector for direct connection
to a host or hub
USB bus powered
Fully assisted hardware or X-On / X-Off
software handshaking
Synchronous Serial (MPSSE) data rates of
up to 30Mbps on JTAG, SPI and I2C
1kByte receive and transmit buffers for
high data throughput
Transmit and receive LED drive signals
Adjustable receive buffer timeout
Support for USB suspend and resume
Low operating and USB suspend current
Low USB bandwidth consumption
UHCI / OHCI / EHCI host controller
compatible
-40°C to +85°C operating temperature
range
Cable length is 0.5m (19.7 inch)
Custom versions also available (subject to
Minimum Order Quantity (MOQ))
FTDI’s royalty-free D2XX drivers eliminate
the requirement for USB driver
development in most cases
Copyright © 2011 Future Technology Devices International Limited
5