Serial Communication Interface (S12SCIV5)
indicating that the received byte can be read. If the receive interrupt enable bit, RIE, in SCI control
register 2 (SCICR2) is also set, the RDRF flag generates an RDRF interrupt request.
11.4.6.3 Data Sampling
The RT clock rate. The RT clock is an internal signal with a frequency 16 times the baud rate. To adjust
for baud rate mismatch, the RT clock (see Figure 11-21) is re-synchronized:
•
•
After every start bit
After the receiver detects a data bit change from logic 1 to logic 0 (after the majority of data bit
samples at RT8, RT9, and RT10 returns a valid logic 1 and the majority of the next RT8, RT9, and
RT10 samples returns a valid logic 0)
To locate the start bit, data recovery logic does an asynchronous search for a logic 0 preceded by three logic
1s.When the falling edge of a possible start bit occurs, the RT clock begins to count to 16.
Start Bit
LSB
RXD
Samples
1
1
1
1
1
1
1
1
0
0
0
0
0
0
0
Start Bit
Qualification
Start Bit
Verification
Data
Sampling
RT Clock
RT CLock Count
Reset RT Clock
Figure 11-21. Receiver Data Sampling
To verify the start bit and to detect noise, data recovery logic takes samples at RT3, RT5, and RT7.
Figure 11-17 summarizes the results of the start bit verification samples.
Table 11-17. Start Bit Verification
RT3, RT5, and RT7 Samples
Start Bit Verification
Noise Flag
000
001
010
011
100
101
110
111
Yes
Yes
Yes
No
0
1
1
0
1
0
0
0
Yes
No
No
No
If start bit verification is not successful, the RT clock is reset and a new search for a start bit begins.
S12P-Family Reference Manual, Rev. 1.13
Freescale Semiconductor
387
FREESCALE [ Freescale ]
