ELECTRICAL CHARACTERISTICS
MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
MAXIMUM RATINGS
Table 2. MAXIMUM RATINGS
All voltages are with respect to ground unless otherwise noted. Exceeding limits on any pin may cause permanent damage to
the device.
Rating
ELECTRICAL RATINGS
Supply Voltage
Analog Chip Supply Voltage under Normal Operation (Steady-
state)
Analog Chip Supply Voltage under Transient Conditions
(1)
Microcontroller Chip Supply Voltage
Input Pin Voltage
Analog Chip
Microcontroller Chip
Maximum Microcontroller Current per Pin
All Pins Except VDD, VSS, PTA0 : PTA6, PTC0 : PTC1
Pins PTA0 : PTA6, PTC0 : PTC1
Maximum Microcontroller V
SS
Output Current
Maximum Microcontroller V
DD
Input Current
LIN Supply Voltage
Normal Operation (Steady-state)
Transient Conditions
ESD Voltage
Human Body Model
(2)
Machine Model
(3)
Charge Device Model
(4)
THERMAL RATINGS
Storage Temperature
Operating Case Temperature
(5)
Operating Junction Temperature
(6)
Peak Package Reflow Temperature During Solder Mounting
(7)
T
STG
T
C
T
J
T
SOLDER
- 40 to 150
- 40 to 115
- 40 to 135
245
°C
°C
°C
°C
V
ESD1
V
ESD2
V
ESD3
± 3000
± 150
± 500
(1)
Symbol
Value
Unit
V
V
SUP(
SS
)
V
SUP(
PK
)
V
DD
- 0.3 to 28
- 0.3 to 40
- 0.3 to 6.0
V
V
IN
(ANALOG)
V
IN
(MCU)
I
PIN
(1)
I
PIN
(2)
I
MVSS
I
MVDD
- 0.3 to 5.5
V
SS
- 0.3 to V
DD
+ 0.3
mA
±15
± 25
100
100
mA
mA
V
V
BUS(SS)
V
BUS(DYNAMIC)
-18 to 28
40
V
Notes
1. Transient capability for pulses with a time of t < 0.5 sec.
2. ESD1 testing is performed in accordance with the Human Body Model (C
ZAP
= 100pF, R
ZAP
= 1500Ω).
3.
4.
5.
6.
7.
ESD2 testing is performed in accordance with the Machine Model (C
ZAP
= 200pF, R
ZAP
= 0Ω).
ESD3 testing is performed in accordance with Charge Device Model, robotic (C
ZAP
= 4.0pF).
The limiting factor is junction temperature, taking into account the power dissipation, thermal resistance, and heat sinking.
The temperature of analog and MCU die is strongly linked via the package, but can differ in dynamic load conditions, usually because
of higher power dissipation on the analog die. The analog die temperature must not exceed 150°C under these conditions
Pin soldering temperature is for 10 seconds maximum duration. Not designed for immersion soldering. Exceeding these limits may
cause malfunction or permanent damage to the device.
908E626
Analog Integrated Circuit Device Data
Freescale Semiconductor
5
FREESCALE [ FREESCALE SEMICONDUCTOR, INC ]
