Table 4-39 FlexCAN2 Registers Address Map (Continued)
(FC2_BASE = $00 FA00)
FlexCAN2 is NOT available in the 56F8166 device
Register Acronym
FC2MB13_DATA
Address Offset
Register Description
Message Buffer 13 Data Register
$AC
$AD
$AE
FC2MB13_DATA
FC2MB13_DATA
Message Buffer 13 Data Register
Message Buffer 13 Data Register
Reserved
FC2MB14_CONTROL
FC2MB14_ID_HIGH
FC2MB14_ID_LOW
FC2MB14_DATA
FC2MB14_DATA
FC2MB14_DATA
FC2MB14_DATA
$B0
$B1
$B2
$B3
$B4
$B5
$B6
Message Buffer 14 Control / Status Register
Message Buffer 14 ID High Register
Message Buffer 14 ID Low Register
Message Buffer 14 Data Register
Message Buffer 14 Data Register
Message Buffer 14 Data Register
Message Buffer 14 Data Register
Reserved
FC2MB15_CONTROL
FC2MB15_ID_HIGH
FC2MB15_ID_LOW
FC2MB15_DATA
FC2MB15_DATA
FC2MB15_DATA
FC2MB15_DATA
$B8
$B9
$BA
$BB
$BC
$BD
$BE
Message Buffer 15 Control / Status Register
Message Buffer 15 ID High Register
Message Buffer 15 ID Low Register
Message Buffer 15 Data Register
Message Buffer 15 Data Register
Message Buffer 15 Data Register
Message Buffer 15 Data Register
Reserved
4.8 Factory Programmed Memory
The Boot Flash memory block is programmed during manufacturing with a default Serial Bootloader
program. The Serial Bootloader application can be used to load a user application into the Program and
Data Flash (NOT available in the 56F8166 device) memories of the device. The 56F83xx SCI/CAN
Bootloader User Manual (MC56F83xxBLUM) provides detailed information on this firmware. An
application note, Production Flash Programming (AN1973), details how the Serial Bootloader program
can be used to perform production flash programming of the on board flash memories as well as other
potential methods.
Like all the flash memory blocks the Boot Flash can be erased and programmed by the user. The Serial
Bootloader application is programmed as an aid to the end user, but is not required to be used or maintained
in the Boot Flash memory.
56F8366 Technical Data, Rev. 6
82
Freescale Semiconductor
Preliminary
FREESCALE [ Freescale ]
