Document Revision History
Version History
Rev 0
Rev 1.0
Rev 2.0
Pre-release, Alpha customers only
Initial Public Release
Added output voltage maximum value and note to clarify in
also removed overall
life expectancy note, since life expectancy is dependent on customer usage and must be
determined by reliability engineering. Clarified value and unit measure for Maximum allowed
P
D
in
Corrected note about average value for Flash Data Retention in
Added new RoHS-compliant orderable part numbers in
Deleted formula for Max Ambient Operating Temperature (Automotive) and Max Ambient
Operating Temperature (Industrial) and corrected Flash Endurance to 10,000 in
Added RoHS-compliance and “pb-free” language to back cover
Added information/corrected state during reset in
Clarified external reference
crystal frequency for PLL in
by increasing maximum value to 8.4MHz.
Replaced “Tri-stated” with an explanation in State During Reset column in
• Added the following note to the description of the TMS signal in
Note:
Always tie the TMS pin to V
DD
through a 2.2K resistor.
• Added the following note to the description of the TRST signal in
Note:
For normal operation, connect TRST directly to V
SS
. If the design is to be used in a debugging
environment, TRST may be tied to V
SS
through a 1K resistor.
Rev. 7
• Remove pullup comment from PWM pins in
• Add
showing current voltage characteristics.
• In
correct interpretation of Calibration Factors to be viewed as worst case
factors.
Description of Change
Rev 3.0
Rev 4.0
Rev 5.0
Rev. 6
Please see http://www.freescale.com for the most current data sheet revision.
56F8366 Technical Data, Rev. 7
2
Freescale Semiconductor
Preliminary
FREESCALE [ FREESCALE SEMICONDUCTOR, INC ]
