56F8013/56F8011 Features
1.1.4
•
Peripheral Circuits for 56F8013/56F8011
One multi-function six-output Pulse Width Modulator (PWM) module
— Up to 96MHz PWM operating clock
— 15 bits of resolution
— Center-aligned and Edge-aligned PWM signal mode
— Four programmable fault inputs with programmable digital filter
— Double-buffered PWM registers
— Taking into account values setting ADC high- and low-limit registers, each complementary
PWM signal pair allows selection of a PWM supply source from:
– PWM generator
– External GPIO
– Internal timers
– ADC conversion result
Two independent 12-bit Analog-to-Digital Converters (ADCs)
— 2 x 3 channel inputs
— Supports both simultaneous and sequential conversions
— ADC conversions can be synchronized by both PWM and timer modules
— Sampling rate up to 2.67MSPS
— 8-word result buffer registers
— ADC Smart Power Management (Auto-standby, auto-powerdown)
One 16-bit multi-purpose Quad Timer module (TMR)
— Up to 96MHz operating clock
— Four independent 16-bit counter/timers with cascading capability
— Each timer has capture and compare capability
— Up to 12 operating modes
One Serial Communication Interface (SCI) with LIN Slave functionality
— Full-duplex or single-wire operation
— Two receiver wake-up methods:
– Idle line
– Address mark
One Serial Peripheral Interface (SPI)
— Full-duplex operation
— Master and slave modes
— Programmable Length Transactions (2 to 16 bits)
One Inter-Integrated Circuit (I
2
C) port
— Operates up to 400kbps
— Supports both master and slave operation
Computer Operating Properly (COP)/Watchdog timer capable of selecting different clock sources
Up to 26 General-Purpose I/O (GPIO) pins with 5V tolerance
Integrated Power-On Reset and Low-Voltage Interrupt Module
•
•
•
•
•
•
•
•
56F8013/56F8011 Data Sheet, Rev. 10
Freescale Semiconductor
Preliminary
7