FUNCTIONAL DESCRIPTION
FUNCTIONAL PIN DESCRIPTION
POWER SUPPLY PIN (VDDI)
RESET TIMER PIN (RT)
Internal supply voltage. A ceramic low ESR 1uF 6V X5R or
X7R capacitor is recommended.
The Reset Timer power-up delay (RT) pin is used to set
the delay between the time when the LDO and switcher
outputs are active and stable and the RST output is released.
An external resistor and capacitor are used to program the
timer. The power-up delay can be obtained by using the
following formula:
ADDRESS PIN (ADDR)
The ADDR pin is used to set the address of the device
when used in an I2C communication. This pin can either be
tied to VDDI or grounded through a 10 kΩ resistor. Refer to
I2C Bus Operation on page 26 for more information on this
pin.
t
D = 10 ms + RtCt
Where Rt is the Reset Timer programming resistor and Ct
is the Reset Timer programming capacitor, both connected in
parallel from RT to ground.
Note Observe the maximum Ct value and expect reduced
accuracy if Rt is less than 10 kΩ.
ENABLE 1 AND 2 PINS (EN1 AND EN2)
These two pins permit positive logic control of the Enable
function and selection of the Power Sequencing mode
concurrently. Table 5 depicts the EN1 and EN2 function and
Power Sequencing mode selection.
RESET OUTPUT PIN (RST)
The Reset Control circuit monitors both the switching
regulator and the LDO feedback voltages. It is an open drain
output and has to be pulled up to some supply voltage (e.g.,
the output of the LDO) by an external resistor.
Both EN1 and EN2 pins have internal pull-down resistors
and both can withstand a short circuit to the supply voltage,
6.0 V.
The Reset Control circuit supervises both output
voltages—the linear regulator output VLDO and the switching
regulator output VOUT. When either of these two regulators
is out of regulation (high or low), the RST pin is pulled low.
There is a 20 µs delay filter preventing erroneous resets.
During power-up sequencing, RST is held low until the Reset
Timer times out.
Table 5. Operating Mode Selection
EN1
EN2
Operating Mode
Regulators Disabled
0
0
1
1
0
1
0
1
Standard Power Sequencing
Inverted Power Sequencing
CLOCK SELECTION PIN (CLKSEL)
No Power Sequencing,
Regulators Enabled
This pin sets the CLKSYN pin as either an oscillator output
or a synchronization input pin. The CLKSEL pin is also used
for the I2C address selection.
CLOCK SYNCHRONIZATION PIN (CLKSYN)
Oscillator output/synchronization input pin.
34701
Analog Integrated Circuit Device Data
Freescale Semiconductor
17
FREESCALE [ Freescale ]
