F81867
backlight brightness control.
General Purpose IO.
GPIO62
INDEX#
CTS5#
I/OOD12st, 5v
This Schmitt-triggered input from the disk drive is
active low when the head is positioned over the
beginning of a track marked by an index hole.
Clear To Send is the modem control input.
PWM2 Output where its frequency range is
183Hz~46.875KHz. It can support various
applications such as manual fan control, and
backlight brightness control.
INst,5v
19
3VCC
INst,5v
PWM 2
OOD12
GPIO63
WPT#
I/OOD12st, 5v
General Purpose IO.
Write protected. This active low Schmitt input from
the disk drive indicates that the diskette is
write-protected.
INst,5v
UART Data Terminal Ready. An active low signal
informs the modem or data set that controller is ready
to communicate.
20
3VCC
DTR5#
PWM 3
O12
PWM3 Output where its frequency range is
183Hz~46.875KHz. It can support various
applications such as manual fan control, and
backlight brightness control.
OOD12
GPIO64
I/OOD12st, 5v
INst,5v
General Purpose IO.
Diskette change. This signal is active low at power on
and whenever the diskette is removed.
DSKCHG#
21
3VCC
Data Set Ready. An active low signal indicates the
modem or data set is ready to establish a
communication link and transfer data to the UART.
DSR5#
INst,5v
5.5 Parallel Port (LPT Port)
Pin No.
Pin Name
Type
PWR Description
FANIN3
INst,5v
Fan 3 tachometer input.
An active high input on this pin indicates that the
printer is selected. Refer to the description of the
parallel port for definition of this pin in ECP and EPP
mode.
102
3VCC
SLCT
GPIO70
PE
INst,5v
I/OOD12st, 5v
INst,5v
General purpose IO.
An active high input on this pin indicates that the
printer has detected the end of the paper. Refer to
the description of the parallel port for the definition of
this pin in ECP and EPP mode.
103
3VCC
OOD12,5v
AOUT
Fan 3 control output. This pin provides PWM
duty-cycle output or a DAC voltage output.
FANCTL3
Power on Strapping pin:
PWM _DAC3
INst,5v
1: PWM mode.
0: Default is DAC mode for FANCTL3 (internal pull
20
Dec, 2011
V0.12P