FWLF15197Dxx SFP Product Specification – October 2006
F i n i s a r
V.
Optical Characteristics (TOP = 0 to 70 °C, VCC = 3.15 to 3.60 Volts)
Parameter
Symbol
Min
Typ
Max
Unit
Ref.
Transmitter
Output Opt. Pwr (EOL)
Optical Wavelength
Wavelength Temperature Dependence
Spectral Width
Optical Extinction Ratio
Sidemode Suppression Ratio
Optical Rise/Fall Time
RIN
POUT
λ
0
+5
(X+6.5)
0.125
1
dBm
nm
nm/°C
nm
dB
dB
ps
dB/Hz
ps
2
3
(X-6.5)
(X+1)
0.08
4
5
Δλ20
ER
SMSRmin
tr/ tf
9.0
30
180
-120
100
2
6
RIN
Transmitter Jitter
Dispersion Penalty at 40 km
Receiver
7
8
dB
Optical Input Power
Optical Input Wavelength
Receiver Jitter
Pin
λC
-23
1450
0
1620
160
dBm
nm
ps
9
7
Notes:
1. Parameters are specified over temperature and voltage, at end of life unless otherwise noted.
2. Class 1 Laser Safety per FDA/CDRH and IEC-825-1 regulations.
3. Over case temperature of 0 to 70 °C. The Transmitter Center Wavelength “X” is as specified by the
customer. The current available wavelengths are: 1470, 1490, 1510, 1530, 1550, 1570, 1590, and 1610
nm. Please see the “Product Selection” section on page 1.
4. Full width, -20dB from peak.
5. Measured filtered, at 1.25 Gb/s. Min represents worst-case ER over temperature and at end of life.
6. Unfiltered, 20% to 80%.
7. Peak to peak.
8. SMF-28 fiber used. 80kms represents 1600ps/nm at 1610nm. Measured at 1.25Gb/s with a PRBS 27-1
pattern at a BER<10-12.
9. Pin represents the range of input powers where BER<10-12. Pin is valid over all data rates specified in
Section IV.
© Finisar Corporation October 2006 Rev.B
Page 5
FINISAR [ FINISAR CORPORATION. ]
