FWLF-1631-XX DWDM SFP Preliminary Product Specification – August 2005
F i n i s a r
VI. Wavelength Stabilization
The laser transmitter will not be turned on until its temperature is adjusted to ensure
operation within the specified channel (X +/- 0.4nm). This temperature stabilization time is
dependent on the ambient temperature conditions, but will typically occur within 30
seconds of powering the device. The device will transmit within the specified wavelength
tolerance (X +/- 0.1nm) within 5 seconds of transmitter operation.
VII. General Specifications
Parameter
Symbol
Min
Typ
Max
Units Notes/Conditions
Data Rate
Total System Budget
BR
0.155
28
2.7
Gb/sec SONET OC-3/12/48 compatible
30
dB @ 2.5 Gb/s, BER <10-12 w/
PRBS 2-23-1. See Note 1
Note 1: Total system budget is defined as Pout – Pin – typical connector losses.
VIII. Environmental Specifications
Parameter
Symbol Min
Typ Max Units Notes/Conditions
Operating Temp
Top
Tsto
-5
70
85
°C Case temperature measured on top-side of
device
Storage Temp
Eye Safety
-10
°C Ambient temperature
CDRH and IEC-825 Class 1 Laser
Product. See Note 1
Note 1: Complies with FDA performance standards for laser products except for deviations pursuant to
Laser Notice No. 50, dated July 26, 2001.
Ó Finisar Corporation
PRELIMINARY and Confidential
Page 7
Rev B, August 2005