FTR-1621T-XX WDM GBIC
Product Specification – December 2004
Finisar
V.
Optical Parameters
Min
(x-4)
Typ
(x+1)
Max
(x+6)
Units Notes/Conditions
nm
Over temperature -40
to 85 °C case
temperature.
See Note 1 below
Parameter
Symbol
TRANSMITTER CHARACTERISTICS
Transmitter Center Wavelength
λ
c
Side Mode Suppression Ratio
(SMSR)
Transmitter Optical Output Power
Transmitter Extinction Ratio
Transmitter Eye Opening
SMSR
P
out
OMI
--
30
-3
8.2
10
+2
dB
dBm Average power coupled
into single mode fiber
dB OC-48 conditions
%
OC-48 Eye Mask
Margin
dB
mUI
Transmitter Reflectance
Transmitter Jitter
RECEIVER CHARACTERISTICS
Optical Input Wavelength
Receiver Optical Input Power
(BER < 10
-9
w/ PRBS 2
23
- 1)
Receiver Optical Input Power
(BER < 10
-12
w/ PRBS 2
23
- 1)
Receiver Reflectance
Dispersion Penalty at 80km
R
TX
-20
75
Parameter per GR-253
3
section 5.6 for OC-48
λ
in
P
in
P
in
R
TX
1450
-28.0
-26.0
1620
-7
-7
-27
2.5
Table 6. Optical parameters
nm
dBm 2.5Gb/s w/
PRBS 2
23
-1, measured
dBm 2.5Gb/s w/
PRBS 2
23
-1, calculated
dB
dB See note 4
Note 1:
The Transmitter Center Wavelength “x” is as specified by the customer. The current available
wavelengths are: 1470, 1490, 1510, 1530, 1550, 1570, 1590, and 1610 nm. Please see the “Product
Selection” section on page 2.
Note 2:
Parameters are specified over temperature and at end of life unless otherwise noted.
Note 3:
All parameters are measured on a Finisar GBIC Evaluation Card unless otherwise noted.
Note 4:
Dispersion penalty measured in loop back. Data rate and pattern used same as specified for
Optical Input Power. Measured at BER= 10
-10
. Fiber used is SMF-28. Exact dispersion (ps/nm) will
vary depending on wavelength of device under test.
© Finisar Corporation December 2004 Rev E
Page 5