FTLX3815M3xx DWDM XFP Product Specification – Nov 2014
F i n i s a r
VIII. Digital Diagnostics Functions
As defined by the XFP MSA1, Finisar XFP transceivers provide digital diagnostic
functions via a 2-wire serial interface, which allows real-time access to the following
operating parameters:
Transceiver temperature
Laser bias current
Transmitted optical power
Received optical power
Transceiver supply voltage
TEC Temperature
It also provides a sophisticated system of alarm and warning flags, which may be used to
alert end-users when particular operating parameters are outside of a factory-set normal
range.
The operating and diagnostics information is monitored and reported by a Digital
Diagnostics Transceiver Controller (DDTC) inside the transceiver, which is accessed
through the 2-wire serial interface. When the serial protocol is activated, the serial clock
signal (SCL pin) is generated by the host. The positive edge clocks data into the XFP
transceiver into those segments of its memory map that are not write-protected. The
negative edge clocks data from the XFP transceiver. The serial data signal (SDA pin) is
bi-directional for serial data transfer. The host uses SDA in conjunction with SCL to
mark the start and end of serial protocol activation. The memories are organized as a
series of 8-bit data words that can be addressed individually or sequentially. The 2-wire
serial interface provides sequential or random access to the 8 bit parameters, addressed
from 000h to the maximum address of the memory.
For more detailed information, including memory map definitions, please see the XFP
MSA documentation1.
Receiver Threshold Adjustment
The FTLX3815M3xx also provide access to receiver decision threshold adjustment via 2-
wire serial interface, in order to improve receiver OSNR performance based on specific
link conditions. It is implemented as follows:
Rx Threshold of XFP transceivers will be factory-set for optimized performance
in non-FEC applications. This will be the default value during both cold start
(power-up) and warm start (module reset).
Rev.: A04
Page 10 of 23
1174161
This document contains proprietary and confidential information to Finisar Corp. This document and the entire information
contained herein, and any other tangible representation thereof, is not to be copied, reproduced, duplicated, distributed, or
modified, in whole or in part, and/or used without the expressed written consent of Finisar Corp.
Printed copy may not be the latest revision please refer to Agile for current revision