FTLF1324P2xTy Industrial Temp. SFP Product Specification – August 2006
Finisar
incoming extinction ratio, an OMA of 0.029 mW corresponds to -16 dBm sensitivity). Measured with
PRBS 2
7
-1 at 10
-12
BER .
10. Measured with PRBS 2
7
-1 at 10
-12
BER .
11. Rate Selectable version in low bandwidth mode.
12. Rate Selectable version in high bandwidth mode.
V.
General Specifications
Parameter
Symbol
BR
BER
L
MAX1
L
MAX2
Min
1062
Typ
Max
4250
10
-12
Units
Ref.
Mb/sec 1
2
km
3
km
3
Data Rate
Bit Error Rate
Max. Supported Link Length on
9/125
μm
SMF @ 4X Fibre Channel
Max. Supported Link Length on
9/125μm SMF @ 1X and 2X Fibre
Channel
Max. Supported Link Length on
9/125μm SMF @ Gigabit Ethernet
4
10
L
MAX3
10
km
3
Notes:
1. Gigabit Ethernet and 1x/2x/4x Fibre Channel compliant.
2. Tested with a PRBS 2
7
-1 test pattern.
3.
Distances are based on FC-PI-2 10.0 and IEEE 802.3 standards.
VI.
Environmental Specifications
Finisar 1310nm Industrial Temperature SFP transceivers have an operating temperature
range from –40°C to +85°C case temperature.
Parameter
Case Operating Temperature
Storage Temperature
Symbol
T
op
T
sto
Min
-40
-40
Typ
Max
85
85
Units
°C
°C
Ref.
VII.
Regulatory Compliance
Finisar transceivers are Class 1 Laser Products and comply with US FDA regulations.
These products are certified by TÜV and CSA to meet the Class 1 eye safety
requirements of EN (IEC) 60825 and the electrical safety requirements of EN (IEC)
60950. Copies of certificates are available at Finisar Corporation upon request.
©
Finisar Corporation August 31, 2006 Rev F
Page 5
FINISAR [ FINISAR CORPORATION. ]
