MC81F4x16
Assures that data in the device matches data in the memory buffer. If your
device is secured, a verification error is detected.
Verify
Erase
Erase the data in your target MCU before programming it.
Set the configuration data of target MCU. The security locking is set with this
button.
Option Selection
Progam the configuration data of target MCU. The security locking is
performed with this button.
Option Write
AUTO
Following sequence is performed ; 1.Erase 2.Program 3.Verify 4.Option Write
Enable the option writing when the „AUTO‟ sequence is executing.
Enable showing the option window when „AUTO‟ button is pressed.
It shows the version information.
Auto Option Write
Auto Show Option
Ver. Info
Log
It shows/hides the log windows
It shows/hides „Hex editor‟. In „Hex editor‟ you can modify the currently loaded
data.
Hex Edit
Fill
Buffer Fill the selected area with a data.
Display the selected page.
Goto
Start ______
End ______
Checksum
Option
Starting address
End address
Display the check sum(Hex decimal) after reading the target device.
It shows currently selected option code in hexadecimal.
It is used to select a target device.
It shows currently selected device.
Device Select
Device
Note:
MCU Configuration value is erased after erase operation. It must be configured to match with
user target board. Otherwise, it is failed to enter ISP mode, or its operation is not desirable.
October 19, 2009 Ver.1.35
185
FINECHIPS [ FINECHIPS ]
