欢迎访问ic37.com |
会员登录 免费注册
发布采购

LM393 参数 Datasheet PDF下载

LM393图片预览
型号: LM393
PDF下载: 下载PDF文件 查看货源
内容描述: 双路差分比较器 [Dual Differential Comparator]
分类和应用: 比较器
文件页数/大小: 4 页 / 72 K
品牌: FCI [ FIRST COMPONENTS INTERNATIONAL ]
 浏览型号LM393的Datasheet PDF文件第2页浏览型号LM393的Datasheet PDF文件第3页浏览型号LM393的Datasheet PDF文件第4页  
LM393 Dual Differential Comparator
DUAL DIFFERENTIAL COMPARATORS
The LM393 dual differential comparator is
made up of two voltage comparators that
operate using the same power supply. THe
supply voltage can range from 2 to 36 volts.
Dual supplies can also be used as long as the
difference between them is 2 to 36 volts. The
LM393 is designed to operate at a temperature
range of 0
o
C to 70
o
C.
FEATURES
l
l
l
l
l
l
l
Single or dual supplies
2 to 36 V Supply
Low Input Bias Current
Low Input Offset Voltage
Low Input Offset Current
Low Supply Current Drain
Output Compatible with TTL, MOS,
and CMOS
PIN ARRANGEMENT
8 DIP
LM393CD
8 SOP
LM393CS
ABSOLUTE MAXIMUM RATINGS
Item
Power Supply Voltage
Input Differential Voltage Range
Input Common Mode Voltage Range
Output Short Circuit-to-Ground
Output Sink Current (1)
Power Dissipation @ 25
o
C
Derate above 25
o
C
Operating Ambient Temperature Range
Operating Junction Temperature
Storage Temperature Range
Symbol
V
CC
V
IDR
V
ICR
I
SC
I
Sink
P
D
1/R
θJA
T
A
T
J
T
S
Rating
+36 or +18
36
-0.3 to +36
Continuous
20
570
5.7
0 to 70
125
-65 to 150
Unit
V
V
V
mA
mW
mW/
o
C
o
o
o
C
C
C
Notes: 1. The max. output current may be as high as 20 mA, independent of the magnitude of V
CC
, output short circuits to
V
CC
can cause excessive heating and eventual destruction.
2. At output switch point, V
O
=
1.4 Vdc, R
S
= 0
with V
CC
from 5.0 Vdc to 30 Vdc, and over the full input
common mode range (0V to V
CC
= –1.5V).
3. Due to the PNP transistor inputs, bias current will flow out of the inputs. This current is essentially constant,
independent of the output state, therefore, no loading changes will exist on the input lines.
4. Input common mode of either input should not be permitted to go more than 0.3V negative of ground or minus
supply. The upper limit of common mode range is V
CC
–1.5V.
5. Response time is specified with a 100mV step and 5.0mV of overdrive. With larger magnitudes of overdrive faster
response times are obtainable.
6. The comparator will exhibit proper output state if one of the inputs becomes greater than V
CC
, the other input
must remain within the common mode range. The low input state must not be less than –0.3V of ground or minus
supply.
5-16