MP7616
ELECTRICAL CHARACTERISTICS (CONT’D)
NOTES:
1
Full Scale Range (FSR) is 10V for unipolar mode.
Guaranteed but not production tested.
Digital input levels should not go below ground or exceed the positive supply voltage, otherwise damage may occur.
Specified values guarantee functionality. Refer to other parameters for accuracy.
2
3
4
5
Linearity error is degraded by 65µV for every mV of voltage offset at output amplifier.
6
Output leakage current refers to I
. One LSB of current constantly flows into I
(30nA at 5kΩ input impedance,
OUT1
OUT2
V
REF
= +10 V) due to ladder termination into I
.
OUT2
Specificationsare subject to change without notice
ABSOLUTE MAXIMUM RATINGS (TA = +25°C unless otherwise noted)1, 2
VDD to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 to +17 V
Digital Input Voltage to GND . . . . GND –0.5 to VDD +0.5 V
IOUT1, IOUT2 to GND . . . . . . . . . . . GND –0.5 to VDD +0.5 V
Storage Temperature . . . . . . . . . . . . . . . . . –65°C to +150°C
Lead Temperature (Soldering, 10 seconds) . . . . . . +300°C
Package Power Dissipation Rating to 75°C
V
REF to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +25 V
CDIP, PDIP, SOIC . . . . . . . . . . . . . . . . . . . . . . . . 1000mW
Derates above 75°C . . . . . . . . . . . . . . . . . . . . . 13mW/°C
VRFB to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +25 V
NOTES:
1
Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a
stress rating only and functional operation at or above this specification is not implied. Exposure to maximum rating
conditions for extended periods may affect device reliability.
2
Any input pin which can see a value outside the absolute maximum ratings should be protected by Schottky diode clamps
(HP5082-2835) from input pin to the supplies.
APPLICATION NOTES
Refer to Section 8 for Applications Information
Rev. 2.00
4
EXAR [ EXAR CORPORATION ]
