DATASHEET
SMD Low Power LED
61-238/XK2C-SXXXXXXXXXX/ET
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within once
in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of
each terminal. Be careful because the damage of the product is often started at the time of the hand
solder.
5. Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether
the characteristics of the LEDs will or will not be damaged by repairing.
Copyright © 2010, Everlight All Rights Reserved. Release Date : 06-Apr.-2011. Issue No: v1
14
www.everlight.com
Device No: DSE-000
EVERLIGHT [ EVERLIGHT ELECTRONICS CO., LTD ]
