Technical Data Sheet
204-15/T1C3-4QSA
6. Soldering Condition
Careful attention should be paid during soldering. When soldering, leave more then 3mm
from solder joint to case, and soldering beyond the base of the tie bar is recommended.
Avoiding applying any stress to the lead frame while the LEDs are at high temperature
particularly when soldering.
Recommended soldering conditions:
Hand Soldering
400℃ Max. (30W
DIP Soldering
Temp. at tip of iron
Preheat temp.
Bath temp.
100℃ Max. (60 sec Max.)
Max.)
Soldering time
Distance
3 sec Max.
265 Max.
3mm Min.(From solder Bath time.
joint to case)
5 sec Max.
Distance
3mm Min.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: 886-2-2267-2000, 2267-9936
Fax: 886-2267-6244, 2267-6189, 2267-6306
http:\\www.everlight.com
Everlight Electronics Co., Ltd.
Device Number: DLE-020-416
http\\:www.everlight.com
Established date:06-07-2007
Rev
1
Page: 10 of 10
Established by: AmY Ma
EVERLIGHT [ EVERLIGHT ELECTRONICS CO., LTD ]
