DATASHEET
SMD . B
19-213-G6SC-M0P1Q1B0E-3T-AM
(B) Recommend soldering pad
Note: Tolerances unless mentioned ±0.1mm. Unit = mm
2. Current limiting
A resistor should be used to limit current spikes that can be caused by voltage fluctuations. Otherwise
damage could occur.
3. Storage
3.1 Moisture proof bag should only be opened immediately prior to usage.
3.2 Environment should be less than 30℃ and 60% RH when moisture proof bag is opened.
3.3 After opening the package MSL Conditions stated on page 1 of this spec should not be exceeded.
3.4 If the moisture sensitivity card indicates higher than acceptable moisture, the component should be baked
at min. 60deg +/-5deg for 24 hours.
4. Iron Soldering
Hand soldering is not recommended for regular production. These guidelines are for rework only. Soldering
iron tip should contact each terminal no more than 3 sec at 350℃, using soldering iron with nominal power
less than 25W. Allow min. 2 sec. between soldering intervals.
5. Usage
13
RevisionCopyright © 2010, Everlight All Rights Reserved. Release Date :September.9.2014 Issue No:DSE-0006941
: (2)
Release Date:
Rev.2
www.everlight.com
Expired Period: Forever
LifecyclePhase:Preliminary
EVERLIGHT [ EVERLIGHT ELECTRONICS CO., LTD ]
