EtronTech
EM6AA160
Extended Mode Register Set (EMRS)
The Extended Mode Register Set stores the data for enabling or disabling DLL and selecting output driver
strength. The default value of the extended mode register is not defined, therefore must be written after power
up for proper operation. The extended mode register is written by asserting low onCS, RAS ,CAS , and WE .
The state of A0 ~ A12, BA0 and BA1 is written in the mode register in the same cycle asCS, RAS ,CAS , and
WE going low. (the device should have all banks idle with no bursts in progress prior to writing into the mode
register, and CKE should be High). A1 is used for setting driver strength to normal, or weak. Two clock cycles
are required to complete the write operation in the extended mode register. The mode register contents can be
changed using the same command and clock cycle requirements during operation as long as all banks are in
the idle state. A0 is used for DLL enable or disable. "High" on BA0 is used for EMRS. Refer to the table for
specific codes.
Table 11. Extended Mode Register Bitmap
BA1 BA0 A12 A11 A10 A9 A8 A7 A6 A5 A4 A3 A2 A1 A0 Address Field
0
1
RFU must be set to “0”
DS1 RFU must be set to “0” DS0 DLL Extended Mode Register
BA0 Mode
A6 A1
Drive Strength
Comment
A0
0
DLL
0
0
1
1
0
1
MRS
0
1
0
1
Full
Weak
RFU
Enable
Disable
EMRS
1
Reserved For Future
Matched impedance Output driver matches impedance
Etron Confidential
10
Rev. 1.3
Mar. /2014