EtronTech
EM68C08CWAG
Figure 11. ODT update delay timing-tMOD
EMRS
NOP
NOP
NOP
NOP
NOP
CMD
CK#
CK
ODT
tIS
tMOD, max
Updating
tAOFD
tMOD, min
Rtt
Old setting
New setting
NOTE 1: To prevent any impedance glitch on the channel, the following conditions must be met:
- tAOFD must be met before issuing the EMRS command.
- ODT must remain LOW for the entire duration of tMOD window, until tMOD, max is met.
then the ODT is ready for normal operation with the new setting, and the ODT signal may be raised again to turned
on the ODT.
NOTE 2: EMRS command directed to EMR(1), which updates the information in EMR(1)[A6,A2], i.e. Rtt (Nominal).
NOTE 3: "setting" in this diagram is the Register and I/O setting, not what is measured from outside.
Figure 12. ODT update delay timing-tMOD, as measured from outside
CK#
CK
EMRS
NOP
NOP
NOP
NOP
NOP
CMD
ODT
tIS
tAOND
tAOFD
tMOD, max
Rtt
Old setting
New setting
NOTE 1: EMRS command directed to EMR(1), which updates the information in EMR(1)[A6,A2], i.e. Rtt (Nominal).
NOTE 2: "setting" in this diagram is measured from outside.
Rev. 1.1
38
Apr. /2016
ETRON [ ETRON TECHNOLOGY, INC. ]
