AT commands
Command mode options
Resets or displays the count of acknowledgment failures. This register increments when the device
expires the retries without receiving an ACK on a packet transmission. This count saturates at its
maximum value. Set the count to zero to reset the count.
Parameter range
0 - 0xFFFF
Default
N/A
DD (Device Type Identifier)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Stores the Digi device type identifier value. Use this value to differentiate between multiple XBee
devices.
Parameter range
0 - 0xFFFFFFFF
Default
0x10000
Command mode options
The following commands are Command mode option commands.
CT (Command mode Timeout)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Sets or displays the Command mode timeout parameter. If a device does not receive any valid
commands within this time period, it returns to Idle mode from Command mode.
Parameter range
2 - 0x1770 (x 100 ms)
Default
0x64 (10 seconds)
CN (Exit Command mode)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Exits Command mode and returns the product family to Idle mode.
Parameter range
N/A
Default
N/A
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
106
ETC [ ETC ]
