AT commands
I/O line passing commands
The source address of the device to which outputs are bound. If an I/O sample is received from the
address specified, any pin that is configured as a digital output or PWM changes its state to match
that of the I/O sample.
Set IA to 0xFFFFFFFFFFFFFFFF to disable I/O line passing.
Set IA to 0xFFFF to allow any I/O packet addressed to this device (including broadcasts) to change the
outputs.
Parameter range
0 - 0xFFFF FFFF FFFF FFFF
Default
0xFFFFFFFFFFFFFFFF (I/O line passing disabled)
T0 (D0 Timeout)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Specifies how long pin D0 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF
T1 (D1 Output Timeout)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Specifies how long pin D1 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF
T2 (D2 Output Timeout)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Specifies how long pin D2 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
102
ETC [ ETC ]
