ESMT
M13S128324A
Operation Temperature Condition -40~85°C
Extended Mode Register Set (EMRS)
The extended mode register stores the data enabling or disabling DLL. The default value of the extended mode register is
not defined, therefore the extended mode register must be written after power up for enabling or disabling DLL. The extended
mode register is written by asserting low on CS , RAS , CAS , WE and high on BA0 (The DDR SDRAM should be in all
bank precharge with CKE already high prior to writing into the extended mode register). The state of address pins
A0,A2~A5,A7~A11 and BA1 in the same cycle as CS , RAS , CAS and WE going low is written in the extended mode
register. A1 and A6 are used for setting driver strength to weak or matched impedance. The mode register contents can be
changed using the same command and clock cycle requirements during operation as long as all banks are in the idle state. A0
is used for DLL enable or disable. “High” on BA0 is used for EMRS. All the other address pins except A0 and BA0 must be set
to low for proper EMRS operation. Refer to the table for specific codes.
BA1 BA0 A11 A10 A9 A8
A7
A6
A5
A4
A3
A2
A1
A0
Address Bus
0
1
RFU: Must be set “0”
D.I.C
RFU: Must be set “0”
D.I.C DLL Extended Mode Register
A6
0
A1
0
Output Driver Impedance Control
A0
0
DLL Enable
Enable
Normal
Weak
0
1
1
Disable
1
0
RFU
1
1
Matched Impedance
BA1 BA0 Operating Mode
0
0
0
1
MRS Cycle
EMRS Cycle
Elite Semiconductor Memory Technology Inc.
Publication Date : Dec. 2007
Revision : 1.0 13/49
ESMT [ ELITE SEMICONDUCTOR MEMORY TECHNOLOGY INC. ]
