PBL 386 40/2
R
V
BExt
R
LRTo
Figure 7. Tipx voltage.
S
TIPX
PBL 386 40/2
RINGX
Notes
1.
The overhead voltage can be adjusted with the R
OV
resistor for higher levels e.g. min 3.1 V
Peak
and is specified
at the two-wire port with the signal source at the four-wire
receive port.
The two-wire impedance is programmable by selection of
external component values according to:
Z
TRX
= Z
T
/|G
2-4S
α
RSN
| where:
Z
TRX
= impedance between the TIPX and RINGX
terminals
Z
T
= programming network between the VTX and RSN
terminals
G
2-4S
= transmit gain, nominally = 1 (or 0.5 see pin PTG)
α
RSN
= receive current gain, nominally = 200 (current
defined as positive flowing into the receive summ-
ing node, RSN, and when flowing from ring to tip).
Higher return loss values can be achieved by adding a
reactive component to R
T
, the two-wire terminating
impedance programming resistance, e.g. by dividing R
T
into two equal halves and connecting a capacitor from the
common point to ground.
The overhead voltage can be adjusted with the R
OV
resistor for higher levels e.g. min 3.1 V
Peak
and is specified
at the four-wire transmit port, VTX, with the signal source
at the two-wire port. Note that the gain from the two-wire
port to the four-wire transmit port is G
2-4S
= 1 (or 0.5 see
pin PTG)
5.
Pin PTG = Open sets transmit gain to nom. 0.0dB
Pin PTG = AGND sets transmit gain to nom. -6.02 dB
Secondary protection resistors R
F
impact the insertion
loss as explained in the text, section Transmission. The
specified insertion loss is for R
F
= 0.
6. The specified insertion loss tolerance does not include
errors caused by external components.
7. The level is specified at the two-wire port.
8. The two-wire idle noise is specified with the port
terminated in 600
Ω
(R
L
) and with the four-wire receive
port grounded (E
RX
= 0; see figure 6).
The four-wire idle noise at VTX is specified with the two-
wire port terminated in 600
Ω
(R
L
). The noise
specification is referenced to a 600
Ω
programmed two-
wire impedance level at VTX. The four-wire receive port is
grounded (E
RX
= 0).
9. Previous state must be active - loop or ground key
detector.
10. If |V
BExt
|
≥
|V
Bat
+ 2 V|, where V
Bat
is the voltage at V
BAT
pin,
the current I
Leak
is limited to
≈
5mA.
2.
3.
4.
7
ERICSSON [ ERICSSON ]
