epc110
Absolute Maximum Ratings (Notes 1, 2)
Recommended Operating Conditions
Voltage at any pin except pin VDD
-0.3V to VN +0.3 V
Min.
Max.
Units
Power Supply Voltage at pin VDD
Programming Voltage at pin VDD
-0.3V to +5.5V
-0.3V to +8.0V
Operating supply voltage at VDD
Programming voltage at VDD
3.0
7.0
3.6
8.0
V
V
Power Supply Voltage at pin VDD33
Output current at any pin except pin LED
Power Consumption with maximum load
Lead Temperature solder, 4 sec. (TL)
-0.3V to +5.5V
-6mA to +6mA
125 mW
Operating supply voltage at VDD33
Operating Temperature (TO)
3.0
3.6
V
C
-40°
+85°
+260°C
Humidity (non-condensing)
+5
+95
%
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Recommended operating conditions
indicate conditions for which the device is intended to be functional, but do not guarantee specific performance limits. For guaranteed specific -
ations and test conditions, see Electrical Characteristics.
Note 2: This device is a highly sensitive CMOS ac current amplifier with an ESD rating of JEDEC HBM class 0 (<250V). Handling and
assembly of this device should only be done at ESD protected workstations.
Electrical Characteristics
3.0V < VN < 3.6V, -40°C < TA < +85°C, unless otherwise specified
General Data
Symbol Parameter
Conditions/Comments
Values
Typ.
Units
Min.
3
Max.
3.6
3
VN
VPUP
VPP
Operating power supply voltage
at VDD33 (and VDD)
Power-up Threshold Voltage
Voltage at VDD33 when the device starts up
2.4
V
Ripple on supply voltage,
peak to peak
Input pulse IPD NST
36nA
48nA
72nA
108nA
70
150
350
600
2
mV
mV
mV
mV
mA
mA
V
IN
IProg
VOH
VOL
VHOH
VLEDH
ILED
VIH
Current consumption operating
in operation mode, IPD = 0 mA, no load
Current consumption programming in program mode, VDD @ 8.0V, IPD = 0 mA, no load
4
Output high voltage
Output low voltage
Output high voltage OUTH
Output high voltage LED
Source current maximum
Input high voltage
except OUTH and LED
VN - 0.5V
@ 4mA source, including OUTH and LED
see Figure 8
0.5
V
@ 0.1mA sink current
VN - 0.5V
0.7
V
mA
V
at Pin LED, VLED @ 0... VN - 1.0V
1.3
VN
0.7*VN
GND
VIL
Input low voltage
0.3*VN
10
V
ILEAKD
RPU
fclk
Input leakage current
Pull-up resistor
µA
kΩ
MHz
internal at digital input
30
200
Reference clock
of internal oscillator - for information only
32
All internal timings are referenced to this clock
dfclk
Temperature drift
of the oscillator - for information only
640
ppm/K
© 2011 ESPROS Photonics Corporation
Characteristics subject to change without notice
2
Datasheet epc110 - V2.1
www.espros.ch
EPC [ ESPROS PHOTONICS CORP ]
