eorex
EP1117
Pin Assignment
Ordering Information
Pin Description
Pin
1
Name
Function
A resistor divider from this pin to the Vout pin and ground sets the
output voltage. (Ground only for Fixed-Mode)
FB/GND
The output of the regulator. A minimum of 10uF capacitor (0.15ꢀ ≤
ESR ≤ 20ꢀ) must be connected from this pin to ground to insure
stability.
2
3
VOUT
The input pin of regulator. Typically a large storage capacitor (0.15ꢀ
≤ ESR ≤ 20ꢀ) is connected from this pin to ground to insure that the
input voltage does not sag below the minimum dropout voltage
during the load transient response. This pin must always be 1.3V
higher than Vout in order for the device to regulate properly.
VIN
Jul. 2006
www.eorex.com
2/10
EOREX [ EOREX CORPORATION ]
