EM42BM1684RBA
Mode Register Definition
Mode Register Set
The mode register stores the data for controlling the various operating modes of DDR SDRAM which
contains addressing mode, burst length, /CAS latency, test mode, DLL reset and various vendor＇s
specific opinions. The defaults value of the register is not defined, so the mode register must be written
after EMRS setting for proper DDR SDRAM operation. The mode register is written by asserting low on /CS,
/RAS, /CAS, /WE and BA0 ( The DDR SDRAM should be in all bank precharge with CKE already high prior
to writing into the mode register. ) The state of the address pins A0-A12 in the same cycle as /CS, /RAS,
/CAS, /WE and BA0 going low is written in the mode register. Two clock cycles are requested to complete
the write operation in the mode register. The mode register contents can be changed using the same
command and clock cycle requirements during operating as long as all banks are in the idle state. The
mode register is divided into various fields depending on functionality. The burst length uses A0-A2,
addressing mode uses A3, /CAS latency (read latency from column address) uses A4-A6. A7 is used for
test mode. A8 is used for DDR reset. A7 must be set to low for normal MRS operation.
Dec. 2010
19/23
www.eorex.com
EOREX [ EOREX CORPORATION ]
