EN29F010
completed the program or erase operation. If it is still toggling, the device did not complete the operation
successfully, and the system must write the reset command to return to reading array data.
The remaining scenario is that the system initially determines that the toggle bit is toggling and DQ5 has
not gone high. The system may continue to monitor the toggle bit and DQ5 through successive read
cycles, determining the status as described in the previous paragraph. Alternatively, it may choose to
perform other system tasks. In this case, the system must start at the beginning of the algorithm when it
returns to determine the status of the operation (top of Flowchart 6).
Table 6. Status Register Bits
DQ
Name
Logic Level
Definition
Erase Complete or
erase Sector in Erase suspend
Erase On-Going
‘1’
‘0’
DATA
Program Complete or
7
POLLING
DQ7
data of non-erase Sector during Erase Suspend
DQ7
‘-1-0-1-0-1-0-1-’
DQ6
Program On-Going
Erase or Program On-going
Read during Erase Suspend
TOGGLE
BIT
6
5
Erase Complete
‘-1-1-1-1-1-1-1-‘
‘1’
‘0’
Program or Erase Error
ERROR BIT
Program or Erase On-going
Chip Erase, Erase or Erase suspend on
currently addressed
‘-1-0-1-0-1-0-1-’
DQ2
Sector. (When DQ5=1, Erase Error due to
currently addressed Sector. Program during
Erase Suspend on-going at current address
TOGGLE
BIT
2
Erase Suspend read on
non Erase Suspend Sector
Notes:
DQ7
Polling: indicates the P/E status check during Program or Erase, and on completion before checking bits DQ5
DATA
for Program or Erase Success.
DQ6 Toggle Bit: remains at constant level when P/E operations are complete or erase suspend is acknowledged.
Successive reads output complementary data on DQ6 while programming or Erase operation are on-going.
DQ5 Error Bit: set to “1” if failure in programming or erase
DQ2 Toggle Bit: indicates the Erase status and allows identification of the erased Sector.
This Data Sheet may be revised by subsequent versions
or modifications due to changes in technical specifications.
©2003 Eon Silicon Solution, Inc., www.essi.com.tw
13
Rev. A, Issue Date: 2003/10/20