AGQ150-48S05 DC-DC Converter
12/13
Pin Designations
Pin NO.
Name
Function
1
Vin+
Positive input voltage
Remote control
2
3
4
5
6
7
8
Remote ON/OFF
Vin-
Vo-
S-
Negative input voltage
Negative output voltage
Negative remote sense
Output voltage trim
Trim
S+
Positive remote sense
Positive output voltage
Vo+
Soldering
The product is intended for standard manual or wave soldering.
When wave soldering is used, the temperature on pins is specified to maximum 260°C for
maximum 7s.
When manual soldering is used, the iron temperature should be maintained at 300°C ~ 380°C and
applied to the converter pins for less than 10s. Longer exposure can cause internal damage to the
converter.
Cleaning of solder joint can be performed with cleaning solvent IPA or similative.
Thermal Considerations
Note: When the temperature of this
test point is lower than 116℃, the
module thermal reliability is available
Figure 18 Temperature test point on converter
http://www.emersonnetworkpower.com.cn
EMERSON-NETWORKPOWER [ EMERSON NETWORK POWER ]
