欢迎访问ic37.com |
会员登录 免费注册
发布采购

EKF5280 参数 Datasheet PDF下载

EKF5280图片预览
型号: EKF5280
PDF下载: 下载PDF文件 查看货源
内容描述: USB2.0闪存控制器 [USB2.0 Flash Controller]
分类和应用: 闪存控制器
文件页数/大小: 14 页 / 182 K
品牌: ELAN [ ELAN MICROELECTRONICS CORP ]
 浏览型号EKF5280的Datasheet PDF文件第2页浏览型号EKF5280的Datasheet PDF文件第3页浏览型号EKF5280的Datasheet PDF文件第4页浏览型号EKF5280的Datasheet PDF文件第5页浏览型号EKF5280的Datasheet PDF文件第7页浏览型号EKF5280的Datasheet PDF文件第8页浏览型号EKF5280的Datasheet PDF文件第9页浏览型号EKF5280的Datasheet PDF文件第10页  
eKF5280  
USB2.0 Flash Controller  
Supports saving power (SLEEP) mode  
8K x 13 on chip ROM (Program)  
8-Level stack for subroutine nesting  
MCU runs at 30MHz  
Performance: Read (11M Bytes/s), Write (8M Bytes/s) Max  
Supported OS: Win XP, Win 2000, Win ME, and MAC OS 9.0 & higher.  
Win 98 driver available upon request.  
PackageLQFP48 (7mm * 7mm)  
3 Unique Function Descriptions  
The following special features may be implemented to assist system manufactures in  
making high quality, low cost USB storage systems.  
The eKF5280 supports down-graded/untested NAND Flash. During testing of the  
target NAND flash, if a flawed block is found, the controller will mark and isolate  
this defective block. Consequently, the isolated block is excluded from operation  
thereafter. The test software for this function is included in the supporting  
programs provided with the controller.  
To reduce cost and increase performance & reliability, the eKF5280 is equipped  
with a built-in SRAM Look-Up-Table to support logical-to-physical address  
translation.  
The eKF5280 is also embedded with a built-in ECC function. The real time ECC  
correction maintains the data integrity while preserving the high data transfer rate  
at the same time.  
A wear-level algorithm is implemented in the eKF5280 firmware to prevent oxide  
degradation and subsequent failure from numerous repetitions of flash erase/  
programming operation on the same block at high voltage. This algorithm  
updates the data of a block into different new physical links to alleviate repetitive  
cycling on the same block.  
The eKF5280 is also equipped with a built-in 5 volt to 3.3 volt regulator. So there  
is no need for an external regulator. Hence your BOM cost is reduced.  
No additional driver is required for eKF5280 operation. It works readily with Win  
XP, Win 2000, Win ME, and MAC OS 9.0 & higher (Win 98 is also supported after  
installing a separate driver).  
2 •  
Product Specification (V1.0) 02.23.2006  
(This specification is subject to change without further notice)