欢迎访问ic37.com |
会员登录 免费注册
发布采购

ELM380 参数 Datasheet PDF下载

ELM380图片预览
型号: ELM380
PDF下载: 下载PDF文件 查看货源
内容描述: 电池充电器定时器 [BATTERY CHARGER TIMER]
分类和应用: 电池
文件页数/大小: 4 页 / 32 K
品牌: ELM [ ELM ELECTRONICS ]
 浏览型号ELM380的Datasheet PDF文件第1页浏览型号ELM380的Datasheet PDF文件第2页浏览型号ELM380的Datasheet PDF文件第4页  
ELM380  
Absolute Maximum Ratings  
Storage Temperature....................... -65°C to +150°C  
Note:  
Stresses beyond those listed here will likely damage  
the device. These values are given as a design  
guideline only. The ability to operate to these levels  
is neither inferred nor recommended.  
Ambient Temperature with  
Power Applied....................................-40°C to +85°C  
Voltage on VDD with respect to VSS............0 to +7.5V  
Voltage on any other pin with  
respect to VSS........................... -0.6V to (VDD + 0.6V)  
Electrical Characteristics  
All values are for operation at 25°C and a 5V supply, unless otherwise noted. For further information, refer to note 1 below.  
Characteristic  
Minimum Typical  
Maximum Units  
Conditions  
Supply Voltage, VDD  
VDD rate of rise  
3.0  
5.0  
5.5  
V
see note 2  
0.05  
V/ms  
mA  
VDD = 5V, see note 3  
Average Supply Current, IDD  
1.0  
2.4  
Internal pullup resistances  
(see note 4)  
300  
20  
500  
30  
600  
50  
KW  
KW  
Pin 4 (reset)  
Pin 6 (8/14) & pin 7 (start)  
with 120Hz (60Hz full-wave) clock  
clock input only, see note 5  
Debounce period - start input  
Input current  
50  
msec  
mA  
V
-0.5  
VSS  
+0.5  
0.15 VDD  
VDD  
Input low voltage  
Input high voltage  
Output low voltage  
Output high voltage  
Notes:  
0.85 VDD  
V
0.6  
V
Current (sink) = 8.7mA  
VDD - 0.7  
V
Current (source) = 5.4mA  
1. This integrated circuit is produced with a Microchip Technology Inc.’s PIC12C5XX as the core embedded  
microcontroller. For further device specifications, and possibly clarification of those given, please refer to the  
appropriate Microchip documentation.  
2. This spec must be met in order to ensure that a correct power on reset occurs. It is quite easily achieved  
using most common types of supplies, but may be violated if one uses a slowly varying supply voltage, as  
may be obtained through direct connection to solar cells, or some charge pump circuits.  
3. Pullup resistor currents are not included in this figure.  
4. The value of the internal pullup resistance is both supply and temperature dependent.  
5. This specification represents current flowing through the protection diodes when applying large voltages to  
the clock input (pin 5) through a current limiting resistance. Currents quoted are the maximum continuous.  
3 of 4  
ELM380DSB  
Elm Electronics – Circuits for the Hobbyist  
< http://www.elmelectronics.com/ >