ProLite
1W SMD Emitter
BTP-99XXCG-XX-X/W
IR Reflow Process Notes
Occasionally there is a brightness decrease due to the influence of heat or ambient during air
reflow. It is recommended that customer use nitrogen reflow method.
Repairing should not be done after the LEDs have been soldered. When repairing is required,
double-head soldering iron should be used. Customer should confirm whether the
characteristics of the LEDs will or will not damaged before carrying out the repair.
Reflow soldering should not be done more than two times
When soldering, do not put stress on the LEDs during heating.
After soldering, do not warp the circuit board.
Manual Hand Soldering Notes
For prototype builds or small production runs, it is possible to place and solder the emitters.
It is recommended to hand solder the leads and slug with a solder tip temperature of 230ºC for
less than 10seconds. This profile ensures a junction temperature below the maximum of 120ºC,
avoiding damage to the emitter or to the MCPCB dielectric layer. Damage dielectric layer can
cause a short circuit in the array.
Other Important Notes:
The information contained herein is presented only as a Guide for the application of our
products. Brilliance Technologies assumes no responsibility for any infringement of intellectual
property or other rights of the third parties which may result from its use.
Brilliance Technologies continually improves the quality of our products. Nevertheless,
semiconductor devices in general can malfunction or fail due to their inherent electrical
sensitivity and vulnerability to physical stress.
It is the responsible of the customer, when
using Brilliance Technologies products, to comply with the standard of safety in making a safe
design for the entire system, and to avoid situations in which a malfunction or failure of such
Brilliance Technologies products cause loss of human life, bodily injury or damage to property.
Brilliance Technologies products listed in this data sheet are intended for usage in general
electronics and/or non-commercial or industrial lighting products. These products are neither
intended nor warranted for usage in equipment that requires extraordinarily high quality and/or
reliability or a malfunction or failure of which may cause loss of human life or bodily injury.
In developing your design, please ensure that Brilliance Technologies products are used within
specified operating ranges as set forth in the most recent Brilliance Technologies data sheets.
BT-Rev. 1.0A20050119
Specifications are subject to change for improvement without notice.
Copyright © 2003 Brilliance Technologies Co., Ltd. All rights reserved.
Part No.: BTP-99XXCG-XX-X/W
Rev1.2005
Page 10 of 10
DB LECTRO Inc. 3600 boul. Matte suite i Brossard Qc J4Y-2Z2 tel:(450)-444-1424 fax:(450)-444-4714 www.dblectro.com
DBLECTRO [ DB LECTRO INC ]
