DS1075-IND
Figure 5
Figure 6
SELECT TIMING
If the PDN bit is set to 0, the PDN /SELX pin can be used to switch between the internal oscillator and an
externalor crystal reference. The “Enabling Sequencer” is again employed to ensure this transition occurs
in a glitch-free fashion. Two asynchronous clock signals are involved, INTCLK is the internal reference
oscillator divided by one or whatever value of M is selected. EXTCLK is the clock signal fed into the
OSCIN pin, or the clock resulting from a crystal connected between OSCIN and XTAL. The behavior of
OUT0 is described in the following paragraphs, the OUT pin will behavior similarly but will be divided
by N.
FROM INTERNAL TO EXTERNAL CLOCK
This is accomplished by a high to low transition on the SELX pin. This transition is detected on the
falling edge of INTCLK. The output OUT0 will be held low for a minimum of half the period of
INTCLK (tI/2), then if EXTCLK is low it will be routed through to OUT0. If EXTCLK is high the
switching will not occur until EXTCLK returns to a low level.
7 of 17