DS1010
NOTES:
1. All voltages are referenced to ground.
2. Measured with outputs open.
3. V
CC
= 5V @ 25°C. Input-to-tap delays accurate on both rising and falling edges within ±2 ns or ±5%
whichever is greater.
4. See “Test Conditions” section.
5. For DS1010 delay lines with a TAP 10 delay of 100 ns or greater, temperature variations from 25°C
to 0°C or 70°C may produce an additional input-to-tap delay shift of
±2ns
or
±3%,
whichever is
greater.
6. For DS1010 delay lines with a TAP 10 delay less than 100 ns, temperature variations from 25°C to
0°C or 70°C may produce an additional input-to-tap delay shift of
±1
ns or
±9%,
whichever is greater.
7. All tap delays tend to vary unidirectionally with temperature or voltage changes. For example, if TAP
1 slows down, all other taps will also slow down; TAP 3 can never be faster than TAP 2.
8. Pulse width and period specifications may be exceeded; however, accuracy will be application-
sensitive (decoupling, layout, etc.).
9. Certain high-frequency applications not recommended for -50 in 16-pin package. Consult factory.
TIMING DIAGRAM: SILICON DELAY LINE
Figure 2
4 of 6
DALLAS [ DALLAS SEMICONDUCTOR ]
